OBD-I Codes List

Ford 224 PCM detected a primary circuit failure on ignition coils 1, 2, 3 or 4 (EI)

Make
Ford (1981-1995)
Category
Powertrain - Ignition
Severity
Check Engine Light

How to read it

Code 224 reads as 2 flashes, pause, 2 flashes, pause, 4 flashes on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 224 mean?

PCM detected a primary circuit failure on ignition coils 1, 2, 3 or 4 (EI)

Common causes of 224

  • The primary circuit on ignition coils 1, 2, 3 or 4 is open or damaged.
  • One of the ignition coils failed.
  • The ICM cannot drive the coil primary circuits.
  • The wiring from the ICM to the coils is damaged.
  • The ECM sees no primary current on a coil.

How to fix 224

  1. Check the wiring from the ICM to ignition coils 1 through 4 for damage.
  2. Test each ignition coil and replace any that fails its own test.
  3. Test the ICM and replace it only if it fails its own test.
  4. Test the ECM last, only after every circuit test has passed.
  5. Clear the code, then retest to confirm every coil fires.

Source

Source review recorded

Sources and review

Review: checked against the recorded source material.

Last updated 2026-10-10.

Report a correction for 224. Include your vehicle, the issue and a source if you have one.