OBD-I Codes List

Ford 241 Ignition control module diagnostic monitor signal malfunction

Make
Ford (1981-1995)
Category
Powertrain - Ignition
Severity
Check Engine Light

How to read it

Code 241 reads as 2 flashes, pause, 4 flashes, pause, 1 flash on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 241 mean?

Ignition control module diagnostic monitor signal malfunction

Common causes of 241

  • An open or short in the IDM signal wire between the ignition control module and the PCM
  • A failing ignition control module that is not sending the diagnostic monitor signal
  • A poor connector fit or corroded pin at the ignition control module
  • An internal fault in the PCM diagnostic monitor circuit

How to fix 241

  1. Inspect the IDM signal wire from the ignition control module to the PCM for an open, chafing or a poor splice
  2. Check the ignition control module connector pins for corrosion, spread terminals or a poor fit
  3. Test the ignition control module and replace it only if it fails its own test
  4. Test the PCM last, only after every circuit test has passed
  5. Clear the code, then retest to confirm the fix holds

Source

Qualified source review

Sources and review

Review: qualified. Read the source limits below.

Last updated 2026-10-10.

Report a correction for 241. Include your vehicle, the issue and a source if you have one.