OBD-I Codes List

Ford 29 Insufficient input from the speedometer module or vehicle speed sensor

Make
Ford (1981-1995)
Category
Powertrain - Other
Severity
Check Engine Light

How to read it

Code 29 reads as 2 flashes, pause, 9 flashes on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 29 mean?

Insufficient input from the speedometer module or vehicle speed sensor

Common causes of 29

  • Wiring
  • Vehicle speed interface module
  • VSS
  • ECM

How to fix 29

  1. Check the circuit wiring and harness for damage, chafing or a poor splice
  2. Test the vehicle speed interface module and replace it only if it fails its own test
  3. Test the VSS and replace it only if it fails its own test
  4. Test the ECM last, only after every circuit test has passed
  5. Clear the code, then retest to confirm the fix holds

Source

Source review recorded

Sources and review

Review: checked against the recorded source material.

Last updated 2026-09-29.

Report a correction for 29. Include your vehicle, the issue and a source if you have one.