OBD-I Codes List

Ford 513 PCM internal voltage failure (KOEO)

Make
Ford (1981-1995)
Category
Powertrain - Computer and Auxiliary Controls
Severity
Check Engine Light

How to read it

Code 513 reads as 5 flashes, pause, 1 flash, pause, 3 flashes on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 513 mean?

PCM internal voltage failure (KOEO)

Common causes of 513

  • Low supply voltage or a bad ground at the PCM
  • A noisy or unstable voltage reference feed to the PCM
  • Corroded battery terminals or engine grounds
  • An internal PCM voltage regulator fault

How to fix 513

  1. Measure battery and charging voltage and the ground drops at the PCM
  2. Check the battery cables and engine grounds for corrosion
  3. Check the PCM power and ground pins for a poor fit
  4. Test the PCM last, only after every circuit test has passed
  5. Clear the code, then retest to confirm the fix holds

Source

Source review recorded

Sources and review

Review: checked against the recorded source material.

Last updated 2026-10-10.

Report a correction for 513. Include your vehicle, the issue and a source if you have one.