OBD-I Codes List

Ford 536 Brake pedal switch circuit failure or not actuated during the KOER test

Make
Ford (1981-1995)
Category
Chassis
Severity
Check Engine Light

How to read it

Code 536 reads as 5 flashes, pause, 3 flashes, pause, 6 flashes on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 536 mean?

Brake pedal switch circuit failure or not actuated during the KOER test

Common causes of 536

  • The brake pedal was not pressed during the KOER test as the test expects
  • A misadjusted or failed brake pedal position switch
  • A wiring fault in the brake pedal switch circuit
  • An internal fault in the PCM brake input

How to fix 536

  1. Press and release the brake pedal during the KOER test as prompted
  2. Check the brake pedal switch adjustment and operation
  3. Check the brake pedal switch circuit wiring for an open or short
  4. Test the brake pedal switch and replace it only if it fails its own test
  5. Test the PCM last, only after every circuit test has passed
  6. Clear the code, then retest to confirm the fix holds

Source

Source review recorded

Sources and review

Review: checked against the recorded source material.

Last updated 2026-10-10.

Report a correction for 536. Include your vehicle, the issue and a source if you have one.