OBD-I Codes List

Ford 122 Throttle position sensor circuit below minimum voltage

Make
Ford (1981-1995)
Category
Powertrain - Fuel/Air Metering
Severity
Check Engine Light

How to read it

Code 122 reads as 1 flash, pause, 2 flashes, pause, 2 flashes on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 122 mean?

Throttle position sensor circuit below minimum voltage

Common causes of 122

  • The TP sensor is loose and its signal drops below minimum voltage.
  • The TP sensor circuit is open or shorted to ground at the low end.
  • The TP sensor itself failed and reads low at the bottom of its travel.
  • The ECM sees the throttle position signal pinned below minimum.

How to fix 122

  1. Check that the TP sensor is mounted tight and set correctly.
  2. Check the TP sensor circuit for an open or a short to ground.
  3. Test the TP sensor and replace it only if it fails its own test.
  4. Test the ECM last, only after every circuit test has passed.
  5. Clear the code, then retest to confirm the signal rises above minimum.

Source

Source review recorded

Sources and review

Review: checked against the recorded source material.

Last updated 2026-10-10.

Report a correction for 122. Include your vehicle, the issue and a source if you have one.