OBD-I Codes List

Ford 144 No HO2S switch detected

Make
Ford (1981-1995)
Category
Powertrain - Fuel/Air Metering
Severity
Check Engine Light

How to read it

Code 144 reads as 1 flash, pause, 4 flashes, pause, 4 flashes on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 144 mean?

No HO2S switch detected

Common causes of 144

  • The HO2S reported no switch activity to the ECM.
  • The HO2S signal wire or its connector is open or corroded.
  • The HO2S sensor element failed and holds a steady signal.
  • A vacuum leak or a rich injector holds the mixture off the switch point.

How to fix 144

  1. Check the HO2S signal wire and connector for an open or corrosion.
  2. Test the HO2S and replace it only if it fails its own test.
  3. Check for a vacuum leak or a rich injector that holds the mixture steady.
  4. Test the ECM last, only after every circuit test has passed.
  5. Clear the code, then retest to confirm the HO2S switches.

Source

Source review recorded

Sources and review

Review: checked against the recorded source material.

Last updated 2026-10-10.

Report a correction for 144. Include your vehicle, the issue and a source if you have one.