OBD-I Codes List

Ford 195 Cylinder balance test malfunction

Make
Ford (1981-1995)
Category
Powertrain - Other
Severity
Check Engine Light

How to read it

Code 195 reads as 1 flash, pause, 9 flashes, pause, 5 flashes on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 195 mean?

Cylinder balance test malfunction

Common causes of 195

  • The cylinder balance test aborted because an injector circuit fault stopped it.
  • An injector with high resistance dropped its cylinder during the test.
  • The ECM could not finish the cylinder kill sequence.

How to fix 195

  1. Check the injector harness and connectors for damage or a poor fit.
  2. Check the injectors for one with high resistance or a clog.
  3. Run the cylinder balance test again and note which cylinder drops.
  4. Test the ECM last, only after every circuit test has passed.
  5. Clear the code, then retest to confirm the balance test completes.

Source

Qualified source review

Sources and review

Review: qualified. Read the source limits below.

Last updated 2026-10-10.

Report a correction for 195. Include your vehicle, the issue and a source if you have one.