OBD-I Codes List

Ford 65 Overdrive cancel or transmission control switch circuit did not change states

Make
Ford (1981-1995)
Category
Powertrain - Transmission
Severity
Check Engine Light

How to read it

Code 65 reads as 6 flashes, pause, 5 flashes on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 65 mean?

Overdrive cancel or transmission control switch circuit did not change states

Common causes of 65

  • Switch not pressed during the test
  • Faulty overdrive cancel switch
  • Open or shorted switch wiring
  • Blown fuse for the switch circuit
  • Faulty fuel control on 2.3L turbo models

How to fix 65

  1. Confirm the code and repeat the test pressing the switch as the manual describes
  2. Test the overdrive cancel switch for a state change
  3. Inspect the switch wiring and fuse for opens and shorts
  4. Repair wiring or replace the fuse before replacing the switch
  5. Replace the switch only after the circuit test fails

Source

Source review recorded

Sources and review

Review: checked against the recorded source material.

Last updated 2026-09-25.

Report a correction for 65. Include your vehicle, the issue and a source if you have one.