OBD-I Codes List

Ford 624 Electronic pressure control circuit failure

Make
Ford (1981-1995)
Category
Powertrain - Transmission
Severity
Check Engine Light

How to read it

Code 624 reads as 6 flashes, pause, 2 flashes, pause, 4 flashes on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 624 mean?

Electronic pressure control circuit failure

Common causes of 624

  • An open or short in the electronic pressure control circuit
  • A failed electronic pressure control solenoid
  • A poor connection at the transmission connector for the EPC solenoid
  • An internal fault in the PCM EPC driver

How to fix 624

  1. Check the EPC circuit wiring for an open or short
  2. Check the transmission connector pins for the EPC solenoid for corrosion or a poor fit
  3. Test the EPC solenoid and replace it only if it fails its own test
  4. Test the PCM last, only after every circuit test has passed
  5. Clear the code, then retest to confirm the fix holds

Source

Qualified source review

Sources and review

Review: qualified. Read the source limits below.

Last updated 2026-10-10.

Report a correction for 624. Include your vehicle, the issue and a source if you have one.