OBD-I Codes List

Ford 641 Shift solenoid 3 circuit failure

Make
Ford (1981-1995)
Category
Powertrain - Transmission
Severity
Check Engine Light

How to read it

Code 641 reads as 6 flashes, pause, 4 flashes, pause, 1 flash on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 641 mean?

Shift solenoid 3 circuit failure

Common causes of 641

  • An open or short in the shift solenoid 3 circuit
  • A failed shift solenoid 3
  • A poor connection at the transmission connector for solenoid 3
  • An internal fault in the PCM shift solenoid 3 driver

How to fix 641

  1. Check the shift solenoid 3 circuit wiring for an open or short
  2. Check the transmission connector pins for solenoid 3 for corrosion or a poor fit
  3. Test shift solenoid 3 and replace it only if it fails its own test
  4. Test the PCM last, only after every circuit test has passed
  5. Clear the code, then retest to confirm the fix holds

Source

Qualified source review

Sources and review

Review: qualified. Read the source limits below.

Last updated 2026-10-10.

Report a correction for 641. Include your vehicle, the issue and a source if you have one.