OBD-I Codes List

Ford 643 Torque converter clutch circuit failure

Make
Ford (1981-1995)
Category
Powertrain - Transmission
Severity
Check Engine Light

How to read it

Code 643 reads as 6 flashes, pause, 4 flashes, pause, 3 flashes on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 643 mean?

Torque converter clutch circuit failure

Common causes of 643

  • An open or short in the torque converter clutch feed wire
  • A corroded or loose connector pin at the torque converter clutch solenoid
  • A failed torque converter clutch solenoid
  • An internal fault in the PCM torque converter clutch driver

How to fix 643

  1. Check the torque converter clutch feed wire for an open or short
  2. Check the connector pins at the torque converter clutch solenoid for corrosion or a poor fit
  3. Test the torque converter clutch solenoid and replace it only if it fails its own test
  4. Test the PCM last, only after every circuit test has passed
  5. Clear the code, then retest to confirm the fix holds

Source

Qualified source review

Sources and review

Review: qualified. Read the source limits below.

Last updated 2026-10-10.

Report a correction for 643. Include your vehicle, the issue and a source if you have one.