OBD-I Codes List

Ford 920 Shift solenoid 2 circuit malfunction during the KOEO test

Make
Ford (1981-1995)
Category
Powertrain - Transmission
Severity
Check Engine Light

How to read it

Code 920 reads as 9 flashes, pause, 2 flashes, pause, 0 flashes on the check-engine light. Jumper the self-test input to signal return at the test connector, then run the key on engine off self test and the running self test, counting the check-engine flashes each time.

New to flash codes? The How to Read Ford EEC-IV Self-Test Codes walks through the test and what the numbers mean. The general OBD-I guide covers the rest.

What does Ford code 920 mean?

Shift solenoid 2 circuit malfunction during the KOEO test

Common causes of 920

  • A shift solenoid 2 that fails the KOEO circuit check
  • An open or short in the shift solenoid 2 wiring during the KOEO test
  • A failed shift solenoid 2
  • An internal fault in the PCM shift solenoid 2 driver

How to fix 920

  1. Run the KOEO test and confirm the shift solenoid 2 fault
  2. Check the shift solenoid 2 wiring for an open or short
  3. Test shift solenoid 2 and replace it only if it fails its own test
  4. Test the PCM last, only after every circuit test has passed
  5. Clear the code, then retest to confirm the fix holds

Source

Qualified source review

Sources and review

Review: qualified. Read the source limits below.

Last updated 2026-10-10.

Report a correction for 920. Include your vehicle, the issue and a source if you have one.